Intech Micro

Tech Support:

 

Note: This information applies to the 2100-A16 ONLY.
The 2400-A16 and 2400-M-R will auto-detect Modbus operation.

 

Note: For programming the 2100-A16, leave in MicroScan ASCII mode (factory default). Once all channels etc are programmed, follow the steps below to change to Modbus mode.

 

Configure the 2100-A16 (Rev 1.3) for Modbus RTU mode:

1. Power down the 2100-A16
2. Place a jumper on S1-6

(Note: To configure the 2100-A16-NET for Modbus TCP mode, place the jumper in S1-5)

3. Power up the 2100-A16