Base with Sleepers only (Small System)
Base with Sleepers + 2100-XX and Shimaden
Controllers, Remotes
Base with 2300-XX Remotes (and sleepers if required).
Remotes must also be set to Modbus mode.
| ZigBee Wireless Data Links | |
| Base / Remote DIP Switch B |
Base/Remote Function Selection.
|
Switch |
Meaning |
OFF |
ON |
|
1 |
Parity Selection |
None * |
Even |
|
2 |
Protocol Selection |
ASCII |
Modbus RTU |
|
3 |
Base/Remote Selection |
Base |
Remote ** |
|
4 |
Transparent |
Non Trans * |
Transparent |
|
5 |
Connections |
Sleepers Only |
All Types (Remotes + Sleepers) |
|
6 |
RS485 Termination |
N/C * |
ON |
|
7 |
RS485 Bias Gnd |
N/C * |
ON |
|
8 |
RS485 Bias Vcc |
N/C * |
ON |
* always OFF for use with Microscan.
* when using sleepers only, set both DIP Switch 2 and 5 OFF.
** Do not use Remote (Switch 3 ON for Z-2400-TCP).
Example Settings Base
|
Base with Sleepers only (Small System) |
|
|
Base with Sleepers + 2100-XX and Shimaden
Controllers, Remotes |
|
|
Base with 2300-XX Remotes (and sleepers if required).
Remotes must also be set to Modbus mode. |
|
Example Settings Remote
|
Remote with 2100-XX stations, Shimaden Controllers |
|
|
Remote with 2300-XX stations (base must also set to
modbus mode) |
|
