DISCONTINUED Product Line
Please select from a product below:
![Shimaden MR13 Input-Output Controller](https://www.intech.co.nz/wp-content/uploads/2020/01/Shimaden-MR13-Input-Output-Controller.jpg)
MR13 - 3 Input/Output Controller - Discontinued
The MR13 is a 3 channel controller with simultaneous 3-channel display.
![SR1 Controller](https://www.intech.co.nz/wp-content/uploads/2020/08/SR1-Controller-855x855.png)
SR1 - Digital Controller - Discontinued
This controller is a low cost PID controller.
Replaced by the SRS1 – Shallow Digital Controller
![](https://www.intech.co.nz/wp-content/uploads/2019/10/sr253_reduced-small.jpeg)
SR253 - Program Controller - Discontinued
This controller is recommended for the most demanding close tolerance control applications.
Replaced by the SR23 – High Accuracy Digital Controller
![](https://www.intech.co.nz/wp-content/uploads/2019/10/SR35-small-1.jpg)
Shimaden SR30 Series - Digital Controllers - Discontinued
The SR30 series digital controllers accept thermocouple, RTD and current inputs. Outputs are either Relay or SSR drive.
![](https://www.intech.co.nz/wp-content/uploads/2019/10/SR35-small.jpg)
Shimaden SR18 and SR19 - Digital Controllers - Discontinued
The SR18 and SR19 digital controllers accept thermocouple, RTD, voltage and current inputs. Outputs can be either Current, Voltage, Relay or SSR drive.
![](https://www.intech.co.nz/wp-content/uploads/2019/10/SD32-small.jpg)
Shimaden SD32 - Digital Indicator - Discontinued
The SD32 digital indicator accepts thermocouple and RTD input, and has a 3 digit LED display.
![](https://www.intech.co.nz/wp-content/uploads/2019/10/AK-96-small.gif)
JUMO AK-96 - Lockable Protection Cover - Discontinued
Lockable clear protection covers were used for protection against mechanical damage and unintentional or unauthorised manipulation, as well as protecting against dust and splashing water.
![GSM8000](https://www.intech.co.nz/wp-content/uploads/2019/10/GSM8000-small.jpg)
Brainchild - SMS - GSM-8000 (Monitoring & Control from your Cell Phone) - Discontinued
Use Short Message commands from your GSM mobile to enable or disable analogue input alarm, switch input alarm and set relay output on/off.