The End User Licence allows the software to operate on your computer.

Once registered you can:

Run the software on the computer that your software is registered to.
Install the software on other computers and use on demo or agent mode for training.

2 Week Trial 

You may use the End User mode once on a computer to run the software for two weeks for evaluation purposes before deciding to buy it. 
The software must be registered at the end of the trial to allow further operation.

Transfer Licence:

To transfer the licence, you register the software on the new computer, and then not use the software on the old computer.

If the software is locked to a dongle, then you move the dongle to the new computer and not use the software on the old computer.

Expand Licence:

To expand the licence (i.e from R50 to R100, or from R100 to T250 etc), you load a new licence file from your MicroScan agent to allow use of the required modules.

Network Passive User Count

Network passives can be used up to the number allowed in your network licence (located on the network active(s)) at any one time.

See Also

    Module Management
    Software Registration
    Register Software Wizard